Inspect and clean the bellows
Where used
Mach 500 · Mach 300 · Mach 200 · Mach 100
Recommended maintenance interval
Monthly
Supplies
• Clean, lint-free cloth
• Johnson Envy Instant Cleaner or equivalent
To inspect and clean the bellows, do the following:
1. Inspect the bellows for rips and tears.
2. Spray a light, even layer of foam cleaner on the surface of the bellows.
3. Allow time for the cleaner to penetrate the dirt and grease, and then remove it with a clean, lint-
free cloth.
4. Repeat steps 2– 3 as necessary.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 15, 2021 PST
Bellows, bearings, and linear rails maintenance
To Next Page
Loading...
