Pierce time
• Enter the pierce time in seconds. Only use when doing piercing first. This does not affect water
or abrasive cutting times.
Save settings
• To save the settings for the current FlowCut session only, select OK. Settings are applied to
every file opened until you close FlowCut. The next time you open FlowCut settings revert to the
default.
• To save the settings for all future FlowCut sessions, select Save as default. Settings are
applied to every file opened. However, if a file was saved with a particular setup, that setup is
applied to that file.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: UltraPierce Vacuum Assist
To Next Page
Loading...
