To enable the pendant
To enable the pendant, do the following:
1. In FlowCUT, select Run Machine , and then select Click to turn on handheld
operator panel .
2. Press and hold both enabling buttons on the pendant—the pendant is now enabled and
corresponding functionality on the keyboard is disabled.
To disable the pendant
To disable the pendant, do the following:
1. Release both enabling buttons on the pendant.
2. In FlowCUT, select Click to turn off handheld operator panel —the pendant is
now disabled and corresponding functionality on the keyboard is enabled.
© 2021 Flow International Corp.
Retrieved from Flow KB on April 14, 2021 PST
Ancillary option: Remote pendant
To Next Page
Loading...
