Fluke Biomedical ProSim 8 - Set the Cardiac Output Waveform; Set the Baseline Temperature; Set Injectate Temperature; Start a Cardiac Output Simulation

Vital Signs Simulator
Simulate Cardiac Output
45
Set the Cardiac Output Waveform
To set the cardiac output waveform:
1. In the Cardiac Output screen, use  or  to highlight the wave parameter.
2. Push .
3. Push  or  to highlight a waveform name in the list of waveforms.
Table 13 shows the cardiac output waveforms for the Product.
Table 13. Cardiac Output Waveforms
Waveform Description
2.5 L/min Normal waveform with accuracy of 2.5 L/min
5.0 L/min Normal waveform with accuracy of 5.0 L/min
10.0 L/min Normal waveform with accuracy of 10.0 L/min
Interrupted Injectable Interrupted injection waveform
LR Shunt Left to right ventricular shunt
Calibrated Pulse Calibrated square wave pulse
4. Push  to set the wave and go back to the Cardiac Output screen.
Set the Baseline Temperature
To set the baseline temperature:
1. In the cardiac output screen, if not already highlighted, use  or  to
highlight the baseline temperature value.
2. Push .
3. Push  or  to highlight 36 °C, 37 °C, or 38 °C.
4. Push  to set the baseline temperature and go back to the Cardiac Output
screen.
Set Injectate Temperature
To set the injectate temperature:
1. In the cardiac output screen, use  or  to highlight the injectate
temperature value.
2. Push .
3. Push  or  to highlight 0 °C or 24 °C.
4. Push  to set the temperature and go back to the Cardiac Output screen.
As you change the injectate temperature, the calibration coefficient necessary for
the monitor shows on the display.
Start a Cardiac Output Simulation
After you set the parameters for a cardiac output simulation, push the Start
softkey. The simulation completes automatically. To stop the simulation, push the
Stop softkey.