FortiAnalyzer Version 3.0 MR3 Administration Guide
124 05-30003-0082-20060925
Configuring reports Reports
Configuring the report types
Select the type of information you want to include in the report:
• Select Basic to include the most common report types.
• Select All to include all report types. If data does not exist for a report type, that
report will appear with the message “No matching log data for this report.”
• Select Custom to select the reports you want to include. Select the blue arrow
to expand the report categories and select individual reports.
Configuring the report Format
Select the type of results you would like to include in the report.
Figure 59: Report configuration report format
Select the blue arrow to expand the Advanced options.
Service(s) Enter specific services to include in the report. Separate multiple
services with a comma.
Select Not to exclude the service from the report. For example, do
not include any information from a specific service in the log
report.
Message(s) Enter specific email messages you want the report to include from
the email reports. Separate multiple messages with a comma.
Day of the Week Select the days of the week that the information is pulled from the
log files to include in the report.
Report Results Select how the data for the report will be presented. Select to
have the data appear collectively for all devices or for each device
separately. If no selection is made, the FortiAnalyzer will generate
reports for all devices by default.
Resolve Host Names Select to display host names by a recognizable name rather than
IP addresses. For details on configuring IP address host names,
see “IP Aliases” on page 53.
Resolve Service
Names
Select to display network service names rather than port numbers.
For example, HTTP rather than port 80.
Include Summary
Information
Select to include a roll up of the report contents.
Include Table of
Contents
Select to include a table of contents for the report.
To Next Page
Loading...