Configure the FortiAnalyzer unit Configuring the FortiAnalyzer unit
FortiAnalyzer Version 3.0 MR3 Administration Guide
05-30003-0082-20060925 49
Figure 14: NFS share configuration
4 Select the Local Path button to select the folder for the users or groups to access.
5 Select OK.
6 Enter the IP address of the remote system or user ID.
7 Select the type of access rights required and select Add.
8 Select OK.
Setting folder and file privileges
By default, when a user adds a new file or folder, the access rights are Read,
Write, Execute for the owner (user), and Read and Execute for the Admin group
and Others.
The FortiAnalyzer unit enables you to administer the folders and files on the
FortiAnalyzer hard disk as you are setting the access rights. These options are set
in the CLI. For more information, see the config nas share command in the
FortiAnalyzer CLI Reference.
Configuring the FortiAnalyzer unit
Use the system config to setup and maintain the FortiAnalyzer unit’s internal
system configuration.
This section includes the following topics:
• Log Settings
• Log Aggregation
• IP Aliases
• RAID
Local Path
Button
Note: The default permissions for files and folders is read and execute privileges. The
owner of the document also has write privileges. To enable write permissions for users and
groups, you must select the write permission for the folder and for the user and the group.
For details see “Setting folder and file privileges” on page 49.
Note: When sharing a file or folder using NFS, and the user attempts to mount the
FortiAnalyzer hard disk on UNIX, the mount operation may fail. If this occurs, rebooting the
UNIX system corrects this, and the system can mount the FortiAnalyzer hard disk.
To Next Page
Loading...
Need help?
General