Configure the FortiAnalyzer unit Dashboard
FortiAnalyzer Version 3.0 MR3 Administration Guide
05-30003-0082-20060925 33
To restore system settings to factory defaults
1 Go to System > Dashboard.
2 In the System Operations area, select Reset to Factory Default and select Go.
3 Select OK to confirm.
The FortiAnalyzer unit restarts with the configuration it had when it was first
powered on.
Format the log disks
Use the system dashboard to format the FortiAnalyzer log disks. Remember to
back up and log data before formatting the hard disks. The FortiAnalyzer unit is
unavailable for the duration of the format process.
To format the log disks
1 Go to System > Dashboard.
2 In the Systems Operations area, select Format Log Disks and select Go.
3 Select OK to begin the format.
Restoring a FortiAnalyzer unit
Use the following procedure if the FortiAnalyzer unit cannot complete the startup
procedure. When this event occurs, the FortiAnalyzer unit is unresponsive to the
web-based manager or the CLI. The cause may be a corrupted firmware image.
Restoring a FortiAnalyzer-100 or FortiAnalyzer-400
To use the following procedure you must have a TFTP server that the
FortiAnalyzer unit can connect to. The TFTP server IP address must be set to
192.168.1.168.
To upload the firmware image to the FortiAnalyzer unit
1 Make sure the TFTP server is running.
2 Copy the firmware image file to the root directory of the TFTP server. Ensure the
file name is image.out.
3 Start the FortiAnalyzer unit.
As the FortiAnalyzer unit starts, the following message appears on the LCD:
Press any key to begin download.....
4 Immediately press any key to begin the automatic download.
The FortiAnalyzer unit connects to the TFTP server and begins downloading the
firmware image. Once downloaded, the FortiAnalyzer unit loads the firmware and
proceeds with the system startup.
Caution: This procedure resets all FortiAnalyzer settings to their default state. This
includes the interface IP addresses, as well as HTTP, HTTPS, SSH, and telnet access.
See “Configuring the FortiAnalyzer unit” on page 21.
To Next Page
Loading...
Need help?
General