FortiAnalyzer Version 3.0 MR3 Administration Guide
134 05-30003-0082-20060925
Output Alerts
Figure 65: SNMP servers list
Use the Access List to identify where the SNMP server is located and the
administrator for the server.
Adding an SNMP server
To add a new SNMP server
1 Go to Alert > Output > SNMP Access List.
2 Select Create New.
3 Configure the following options, and select OK.
Syslog Servers
Configure the syslog servers where the FortiAnalyzer unit sends log
messages.You must add the syslog server before you can select it as a way for
the FortiAnalyzer unit to communicate an alert.
To view the SNMP servers, go to Alert > Output > Syslog Server.
Create New Select to add a new SNMP server.
Name The name given to the SNMP server.
Community Name The community name for the SNMP server.
IP or FQDN The IP address or fully qualified domain name for the SNMP
server.
Send system traps to Select an inputted trap from SNMP server from the list.
Action Select Delete to remove the SNMP server configuration.
Select Edit to change the SNMP server configuration.
Select Test to verify the SNMP server configuration.
Delete
Edit
Test
Name Enter a name for the SNMP server.
Community Name Enter a community name for the SNMP server.
IP address (or FQDN) Enter the IP address or fully qualified domain name for the SNMP
server.
To Next Page
Loading...
Need help?
General