FortiAnalyzer Version 3.0 MR3 Administration Guide
32 05-30003-0082-20060925
Dashboard Configure the FortiAnalyzer unit
Clicking the column headers sorts the information in ascending or descending
order for that column.
Setting the time
Set the system time to ensure effective scheduling and accurate logging of
information. You can either manually set the FortiAnalyzer system time or you can
configure the FortiAnalyzer unit to automatically keep its system time correct by
synchronizing with a Network Time Protocol (NTP) server.
To set the system time, go to System > Dashboard and select Change for the
System Time.
Figure 4: Time Settings
Restore factory default system settings
You can restore the FortiAnalyzer unit to its factory default. This procedure does
not change the firmware version.
Counter The number of occurrences of the alert event.
Delete icon Select the check box for alert messages you want to delete and
select the delete icon.
System Time The current FortiAnalyzer system date and time.
Refresh Update the display of the current FortiAnalyzer system date and
time.
Time Zone Select the current FortiAnalyzer system time zone.
Set Time Select to set the FortiAnalyzer system date and time to the values
you set in the Year, Month, Day, Hour, Minute and Second fields.
Synchronize with
NTP Server
Select to use an NTP server to automatically set the system date
and time. You must specify the server and synchronization interval.
Server Enter the IP address or domain name of an NTP server. To find an
NTP server that you can use, see http://www.ntp.org.
Sync Interval Specify how often the FortiAnalyzer unit should synchronize its time
with the NTP server. For example, a setting of 1440 minutes causes
the FortiAnalyzer unit to synchronize its time once a day.
Caution: This procedure deletes all changes you have made to the FortiAnalyzer
configuration and reverts the system to its original configuration, including resetting
interface addresses.
To Next Page
Loading...
Need help?
General