100
Disassembly and disposal
Disassembling
the system
Electrical equipment:
DANGER!
Risk of fatal injury from dangerous electrical voltage.
The areas bearing this symbol contain parts that are under dangerous electrical
voltages. Electrically-charged parts (capacitors) can remained charged for a
considerable length of time after they are switched off. An electric shock can be
fatal! Before opening the power source:
- Move the mains switch to the O position
- Switch off all supply leads and unplug them from the mains
- Wait for at least 10 minutes (to allow capacitors to discharge)
- Put up an easy-to-understand warning sign to stop anybody inadvertently
switching it back on again
- Check that the installation is no longer live
- Carry out earthing and short-circuiting
Ensure that:
- all machine components and electrical parts are separated according to type and
disposed of properly
- the consumables used are sorted and separated according to their properties
- all parts and consumables (such as lubricants, coolants, conductive paste, ...) are
disposed of in an environmentally responsible way in accordance with regional legis-
lation and provisions
NOTE! If you have any further questions about disposal / recycling please
address them to the manufacturer.
WARNING!
Danger of environmental damage
Incorrect disassembly and disposal of the separate system componnets can
result in serious environmental damage.
- The separate system components must only be disposed of by
appropriately-qualied technicians.
Disposal of
components
To Next Page
Loading...
