Fronius FPA 3020 Orbital - Main Menu; Safety; Entering a Password

57
Main menu
Entering a
password
If the password entry is pre-set in the „Setup and system parameters“ menu, you will be
requested to enter a valid password each time you switch on the power source.
Safety
With the „CANCEL“ button, only the following functions are available:
- „Setup and system parameters“ menu, but for logging on only
- Welding menu
- Loading programs from the power source memory or USB stick
- Printing out process data
WARNING!
Risk of injury and damage from electric shock!
As soon as the mains switch is in the „I“ position, the tungsten electrode of the
orbital welding gun is LIVE.
- Make sure that the tungsten electrode does not touch
- any persons or electrically conducting or earthed parts (e.g. housing etc.)
(1)
(3)
1. Turn the mains switch to the „ON“
position
2. A window appears requesting you to
enter the password
3. Touch the area marked (1)
IMPORTANT! If you touch the area
marked „CANCEL“ (2), the power source
will go into „Locked“ status and only the
actual welding mode will be supported.
You cannot change any settings.
(2)
4. A keypad appears
5. Enter the password using this
keypad and conrm by pressing the
„tick“ key (3)
IMPORTANT! The default password is
a full stop „.“(Point). If this default pass-
word has been changed and the new
password is not recognised, you cannot
log on using the full stop „.“(Point).