Fronius FPA 3020 Orbital - Calling up Parameters for Wirefeeding or AC Welding; Parameters for Wirefeeding

75
1. Selecting the surface (a) calls up
the settings for the main current
again
IMPORTANT! Depending on the functions
available, one of the buttons below may
appear instead of the „POWER“ button:
- WIRE
parameters for wirefeeding
- AC
parameters for AC welding”
Calling up para-
meters for wire-
feeding or AC
welding
IMPORTANT! If a TIG manual welding torch has been connected instead of the orbital
welding gun, the corresponding windows differ slightly from the following illustrations.
The parameters however are similar.
(a)
5. Wire stop
delay time between the main current and end of wirefeeding [s].
Depending on the selected „DSL“ (Downslope time), and the „traveling down-
slope“.
6. Wire retract path
Path of wire retract after the main current.
7. Use the “AC” button to call up the window for setting the AC parameters
Provide the following information:
1. Different segment
Use the “<<” or “>>” button to select
a different segment
2. Wire start
delay time between start of welding
current and start of wire- feeding [s]
3. Wire Puls Set v
wire feed speed during the pulse
phase [cm/min]
4. Wire Back Set v
wire feed speed during the back-
ground current phase [cm/min]
Parameters for
wirefeeding