Fronius FPA 3020 Orbital - Synergic; Calling up the Synergic Menu; Principle; Entering Parameters

61
Synergic
Principle In synergic mode, it is sufcient merely to enter a few well-known settings for the arc
process. Using this information, the power source calculates all other settings for an
optimum welding result.
Entering
parameters
Calling up the
„Synergic“ menu
Call up the „Synergic“ menu
Provide the following information:
1. Type of base material
- Inox
- Steel
- Alu
- Titan
2. Gas - (shielding gas)
- Argon
3. Wall thickness
Wall thickness of the pipe [mm]
4. Diameter
Outer diameter of pipe join [mm]
5. Conrm settings by pressing OK
The parameters are calculated
IMPORTANT! To make settings for the tack program, touch the „TACK.PR“ button