23
Controls and connections
Control panel
Control panel
(7)
(6)
(5)
(4)
(10)
(9)
(8)
(1)
(2)
(3)
NOTE! As a result of rmware updates, you may nd that there are functions
available on your unit that are not described in these operating instructions or
vice versa. Certain illustrations may also differ slightly from the actual controls
on your unit. However, the functionality of these controls is identical.
WARNING!
Operating the equipment incorrectly can cause serious injury and
damage
Do not use the functions described here until you have read and completely
understood all of the following documents:
- These operating instructions
- all operating instructions for the system components, especially the
“Safety rules”
Nr. Function
(1) Adjusting dial
For selecting a menu item:
1. Turn the adjusting dial until the desired menu item is highlighted
2. Press the adjusting dial to select the menu item
For selecting and adjusting a parameter
1. Turn the adjusting dial until the desired parameter is highlighted in blue
2. Press the adjusting dial; the selected parameter now turns violet
3. Turn the adjusting dial to adjust the parameter to the desired value
4. Press the adjusting dial to apply the value; the blue highlighting then moves
on to the next parameter
IMPORTANT! If you do not wish to apply the value, press the „Esc“ key (8).
IMPORTANT! These functions are also directly supported by the touchscreen (3).
Simply touch a menu item or parameter. Where applicable this will open a list from
which you can select from several values. However, the adjusting dial must be
used to enter a numerical value. It is advisable just to use the adjusting dial when
wor- king, for example, in dusty environments if the touchscreen is covered with
protective foil.
To Next Page
Loading...
