78
Orbital and TIG welding
Safety
Calling up the
„Welding“ menu
Call up the „Welding“ menu. The rst window for the welding process
status appears
Controlling and
monitoring the
welding process
DANGER!
An electric shock can be fatal.
If the device is plugged into the mains electricity supply during installation,
there is a high risk of very serious injury and damage. Only carry out work on
the device when
- the mains switch is in the „O“ position,
- the device is unplugged from the mains.
WARNING!
Operating the equipment incorrectly can cause serious injury and
damage
Do not use the functions described here until you have read and completely
understood all of the following documents:
- These operating instructions
- all operating instructions for the system components, especially the
“Safety rules”
WARNING!
Risk of injury and damage from electric shock!
As soon as the mains switch is in the „I“ position, the tungsten electrode of the
orbital welding gun is LIVE.
- Make sure that the tungsten electrode does not touch
- any persons or electrically conducting or earthed parts (e.g. housing etc.)
WARNING!
Risk of injury and damage from machines that start up automatically!
Automatically starting machines can cause serious injury and property damage
caused by snagging, pulling or crushing of body parts.
- For your personal safety, ensure that all protective measures have been
implemented and will remain in place while you are within the working area
of the welding system
To Next Page
Loading...
