77
Success
programs
(continued)
After the „SELECT“ button has been
touched, a screen opens for the group
that contains the original welding program.
Successor programs are selected here (c).
(c)
Once all the programs have been
selected, programs can be linked using
one of two methods. Touch the
„START POINT“ (f) button. In the
„Positions“ window, the settings for the
„RETURN TRAVEL“ (g) function allow you
to control how the successor programs
behave.
Method 1:
Return travel: „NONE“ (h)
In this mode, all the selected programs are
nested into a single program.
Method 1:
Return travel: „........“ any mode, apart from
„NONE“ (h)
In these modes, all the selected programs
are called separately. Welding stops
between programs, welding restarts and
all necessary movements such as hose-
pack unwinding are performed auto-
matically.
Programm 1
Programm 1
Programm 3
Programm 3
Programm 2
Method 1
Method 2
Programm 2
The selected successor programs are
listed under the original program (d).
Use the << and >> buttons (e) to switch
between programs.
(g) (h)
(d)
(e)
(f)
To Next Page
Loading...
