69
Welding direction
and wirefeeding
Start of L/R
measurement
Provide the following information:
1. Welding direction
Clockwise
Anti-clockwise
IMPORTANT! Only closed welding guns
with no wirefeeding support the anti-
clockwise welding direction.
Use the „WIRE“ button to call up the set-
tings for wire inching.
Provide the following information:
1. Wire inching speed
starting speed for wire inching [cm/
min]
2. Wire start time
time before start speed changes
over to high speed [sec]
Use the „L-R MEASURING“ button to
open the window.
Provide the following information:
1. Start
There is performed an automatic
measurement of the welding circuit
resistance and inductance. The
result is automatically entered in the
display.
2. Cancel
Cancel measurement and close the
window.
3. Rapid motion speed
high-speed welding [as % of the maximum welding speed of the orbital gun]
4. Path adjustment
path adjustment as a percentage. Parameter enables balancing path nominal and
actual value.
5. Welding circuit inductance
Display of the determined value after a measuring operation
6. Welding circuit resistance
Display of the determined value after a measuring operation
3. Wire rapid speed
high-speed wire inching [cm/min]
4. Wire upslope time
the transition from starting speed to high speed is continuous, and is shown as an
upslope. The duration of the transition can be set here.
5. Use the „TIME“ button to call up the settings for date, time and calibrating the
touchscreen
Wire inching
2. Manual speed
welding speed in manual mode
[cm/min]
To Next Page
Loading...
