Fronius FPA 3020 Orbital - Parameter TACK.PR

62
Parameter
TACK.PR
Make the following settings in the „Tack
Program“ window:
- „Tackpoints“
OFF - tacking deactivated
1 .... 20 - number of tack points
- “Tack.Welding time”
duration of welding current for a tack
point [s]
- “Position 1st tack point”
position of the rst tack point
[degrees]
- “Tack gas preow“
shielding gas pre-ow before tacking
- „Tack welding current“
welding current for tacking
- “Tack gas postow”
shielding gas post-ow for tacking
IMPORTANT! On closed orbital welding guns, gas pre-ow and gas post-ow only take
place at the rst and last tack points.