80
Status display of the following parameters:
► PROCESS-ACTIVE-STATUS
► POWER SOURCE STATUS
► LIMIT SWITCH ACTIVE
► ALARM - STATUS FPA
Welding process
status
If the changed parameters are to be
applied:
1. Touch the “ >> “ button (a), to move
to the next page.
Correcting the
welding process
This window appears when a change is made on the remote control. For every segment
(up to a maximum of 10) the latest change to the original value is shown.
For example, if the current for segment „S1“ has been changed by 4 A,
„4“ appears in the relevant eld.
2. Touch the “ Segment 9/10 “ button
(b), to move to the next page.
3. Touch the „CORRECT“ button (c)
or press the „Start/Stop“ button on
the remote control unit.
4. Touch the “BACK” button or press
the “Stop” button on the remote
control unit to close the
window without applying any
changed values.
IMPORTANT! The parameters are
only applied if the following user
permissions are selected: “SAVE”,
“FIND PAR”, and“ADMIN”.
More detailed information on the
user settings can be found in the
“User settings” section.
(a)
(c) (b)
To Next Page
Loading...
