Fronius FPA 3020 Orbital - Display after Welding Is Cancelled

35
Display after
welding is
cancelled
- Date and time
- Orbital welding gun type
- Start —> CONTINUE
press Start/ Stop (11) to start welding
- R+Stop —> BREAK
exit the automatic mode by pressing
the „right“ (14) and „Stop“ (12) keys at
the same time
- Pos
position of the orbital welding gun [°] /
welding speed [cm/min]
- Seg 1
status indicator for current segment
If welding was interrupted because of an alarm, or because Start/Stop, Stop or
Emergency stop was pressed, the following appears:
Start --> CONT.
R.Stop --> BREAK
Pos 0 / 0.0
Seg 1
FCH-6-76
04.12.15 10:20:57