EasyManuals Logo

Fronius FPA 3020 Orbital User Manual

Fronius FPA 3020 Orbital
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
90
Displayed service
codes
tP1 | xxx, tP2 | xxx, tP3 | xxx, tP4 | xxx, tP5 | xxx, tP6 | xxx
Cause: Overtemperature in the primary circuit of the power source
Remedy: Allow the power source to cool down
tS1 | xxx, tS2 | xxx, tS3 | xxx
Cause: Overtemperature in the secondary circuit of the power source
Remedy: Allow the power source to cool down
tSt | xxx
Cause: Overtemperature in the control circuit
Remedy: Allow the power source to cool down
Err | 051
Cause: Mains undervoltage: The mains voltage has dropped below the
tolerance range (see „Technical data“)
Remedy: Check the mains voltage
Err | 052
Cause: Mains overvoltage: The mains voltage has exceeded the upper limit of
the tolerance range (see „Technical data“)
Remedy: Check the mains voltage
no | IGn
Cause: „Ignition time-out“ function is active: No current started owing before
the end of the time specied in the Set-up menu. The safety cut-out of
the power source has been triggered.
Remedy: Restart welding; clean workpiece surface.
Err | PE
Cause: The earth fault current watchdog has triggered the safety cut-out of the
power source.
Remedy: Switch off the power source, wait for 10 seconds and then switch it on
again. If you have tried this several times and the error keeps occurring,
contact After-Sales Service.
Err | IP
Cause: Primary overcurrent Remedy:
Remedy: Contact After-Sales Service
Err | bPS
Cause: Fault in power module
Remedy: Contact After-Sales Service
dSP | Axx, dSP | Cxx, dSP | Exx, dSP | Sy, dSP | nSy
Cause: Fault in central control and regulation unit
Remedy: Contact After-Sales Service
IMPORTANT! If an error message that is not described here appears on the displays,
then the fault is one that can only be put right by a service engineer. Make a note of the
error message shown in the display, and of the serial number and conguration of the po-
wer source, and get in touch with our After-Sales Service, giving them a detailed descrip-
tion of the error.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fronius FPA 3020 Orbital and is the answer not in the manual?

Fronius FPA 3020 Orbital Specifications

General IconGeneral
BrandFronius
ModelFPA 3020 Orbital
CategoryPortable Generator
LanguageEnglish

Related product manuals