Fronius FPA 3020 Orbital - Setup and System Parameters; Calling up the Setup and System Parame- Ters Menu; Principle; Calling up OPERATOR Settings

63
Setup and system parameters
The „Setup and system parameters“ menu allows users to adjust the power source and
orbital welding gun specically to their requirements.
Principle
Calling up
„OPERATOR“
settings
Calling up the
„Setup and
system parame-
ters“ menu
Call up the „Setup and system para- meters“ menu
A detailed description of the menus is provided in the following
sections.
1. Touch the „USER“ button in the
„Ignition parameters“ window
2. A window appears for user-specic
settings
To assign the user’s permissions:
1. Touch the area “RIGTHS” (2) and select one of the following entries:
- LOCKED ...the power source goes immediately into “Locked” status and
only the actual welding mode is supported. You cannot change any settings.
- BASIC ... The user has no permissions, and may only change welding
parameters within the limits specied for him.
- SAVE ... The user may also save the welding parameters changed by him.
- PAR. FINDER ... The user may also change the parameters beyond the
predened limits.
- ADMIN ... The user may also reset parameters and adjust setup and system
para- meters.
If the user name is to be changed
- Touch button (1) to open the keypad for
changing the user name
If the password needs to be changed:
- Touch button (3) to open the keypad for
changing the password
User permissions
(2)
(4)
(5)
(3)
(1)