16
Safety precau-
tions in normal
operation
Preventive and
corrective main-
tenance
Only operate the machine if all of its protective features are fully functional. If
any of the protective features are not fully functional, this endangers:
- the life and well-being of the operator or other persons
- the equipment and other tangible assets belonging to the owner/operator
- efcient working with the equipment.
Any safety devices that are not fully functional must be put right before you
switch on the machine.
Never evade safety features and never put safety features out of order.
Before switching on the machine, ensure that nobody can be endangered by
your doing so.
- At least once a week, check the machine for any damage that may be visible from the
outside, and check that the safety features all function correctly.
- Always fasten the shielding-gas cylinder rmly, and remove it altogether before
hoisting the machine by crane.
- Owing to its special properties (in terms of electrical conductivity, frostproong,
materials-compatibility, combustibility etc.), only original coolant of the manufacturer is
suitable for use in our machines.
- Only use suitable original coolant of the manufacturer.
- Do not mix original coolant of the manufacturer with other coolants.
- If any damage occurs in cases where other coolants have been used, the manu-
facturer shall not be liable for any such damage, and all warranty claims shall be null
and void.
- Under certain conditions, the coolant is ammable. Only transport the coolant in
closed original containers, and keep it away from sources of ignition.
- Used coolant must be disposed of properly in accordance with the relevant national
and international regulations. A safety data sheet is available from your service centre
and on the manufacturer’s homepage.
- Before starting welding - while the machine is still cool - check the coolant level.
With parts sourced from other suppliers, there is no certainty that these parts will have
been designed and manufactured to cope with the stressing and safety requirements
that will be made of them. Use only original spares and wearing parts (this also applies
to standard parts).
Do not make any alterations, installations or modications to the machine without getting
permission from the manufacturer rst.
Replace immediately any components that are not in perfect condition.
When ordering spare parts, please state the exact designation and the relevant part
number, as given in the spare parts list. Please also quote the serial number of your
machine.
To Next Page
Loading...
Need help?
General
