Fronius FPA 3020 Orbital - Printer Configu- Ration Menu

49
Open the menu by pressing the „Printer conguration“ key
Provide the following information:
„Printer congu-
ration“ menu
1. Realvalue Printout“ for relevant
process data
Options include:
► No Print Out
► Printer
Prints to paper using the integral
printer
► USB Stick
No printing occurs. Instead, the
relevant data is saved to the
USB stick.
► Printer & USB
Data is printed and also saved to
USB stick.
Every xx degrees - data is printed at the following angle intervals:
- „OFF“ ... do not document
- „5 Deg“ ... document every 5°
- „10 Deg“ ... document every 10°
- „15 Deg“ ... document every 15°
- „20 Deg“ ... document every 20°
- „45 Deg“ ... document every 45°
and only for every xx-th seam, as per the „every xx seams“ entry
2. “Alarm Printout”
Settings are made in the same way as those for “Realvalue Printout”, but for print-
ing out alarm messages in this case
3. “Parameter Printout”
Settings made in the same way as those for “Realvalue Printout”, but for printing
out relevant process parameters for the loaded program in this case
4. “Start-Stop Printout”
Settings made in the same way as those for “Realvalue Printout”, but for printing
out relevant data for welding start and stop in this case
IMPORTANT! To change the printer paper:
- Remove cover from printer
- Remove remaining paper
- Insert suitable paper roll for thermo sublimation printer
- Replace cover