32
(12) Stop button
Pressing key (12) stops welding immediately.
IMPORTANT! Regardless of the settings in the “Parameter settings” menu, weld-
ing stops with no downslope when key (12) is pressed.
For all orbital welding guns:
Pressing key (12) and the “left” key (13) at the same time sets the present
position of the orbital welding gun to zero.
(13) “Left” key
Pressing the key START/STOP (11) and the “left” key (13) moves the orbital
welding gun back to the starting position.
Pressing key STOP (12) and the “left” key (13) at the same time sets the
present position of the orbital welding gun to zero.
(14) “Right” key
Pressing key STOP (12) and the “right” key (14) at the same time stops welding
immedia- tely, and the previous position is deleted. Welding starts again from the
original start position.
Pressing key STOP (12) and the “right” key (14) at the same time after a stop
of an alarm, or because Start/Stop, Stop or emergency stop was pressed causes
an immediate exit from the automatic mode.
(15) Emergency stop button
Stops welding immediately, without any downslope, for example to prevent an
accident.
IMPORTANT! Pressing the „left“ (13) and „right“ (14) keys at the same time calibrates
the touchscreen in the same way that the „calibrate“ button in dialog window 263
„Date, time and calibrating the touchscreen“ does, as described in the „Setup and system
parameters“ section.
Remote control
unit
(continued)
To Next Page
Loading...
