146
The buttons on the welding torch do not function
Cause: The welding torch is not plugged in
Remedy: Plug in the welding torch
Cause: The cable connection to the LocalNet converter is disconnected
Remedy: Reconnect the cable to the LocalNet converter
Program sticks in the processing screen on starting
Cause: Software error - an unknown USB device was connected during start-up (e.g.
USB flash drive)
Remedy: Remove USB device
If this does not work, reinstall the software using the DVD
Note! All courses and profiles will be deleted
Cause: The cable connection to the LocalNet converter is disconnected
Remedy: Reconnect the cable to the LocalNet converter
Error message on the screen: "No Dongle connected"
Cause: USB dongle not plugged in or is plugged into the wrong USB port
Remedy: Plug USB dongle into a different USB port and restart the Virtual Welding sys-
tem
NOTE!
The dongle should always be connected alone via a USB bank!
To Next Page
Loading...
