21
1st block parameter
Stby
Standby setting (002)
[Description] –––––––––––––––––––––––––––––––––––––––––––––––––––––––
Allows you to switch between run and standby.
Setpoint
Description
oFF
Operation mode
oN
Standby mode
STBY indicator lights during stanby. (see page 11)
When hold alarms is on, the hold function activates when you switch the standby setting from “ oN ” to “ oFF .”
If the instrument is put into standby during auto tuning, the auto tuning is canceled. To complete auto-tuning, turn
standby setting “ oFF ” and restart auto tuning.
When the controller switches to standby mode, the ON delay timer will be reset. It will begin again when standby
setting is turned off.
[Setting example] Switching to Standby mode ––––––––––––––––––––––––––––
Display Operating procedure
1.
Press and hold the key for about one second during the SV/PV display.
appears.
2.
Press the key to display .
3.
Press the key.
The setpoint starts blinking.
4.
Press the or keys to change “ oFF ” to “ oN .”
5.
Press the key or wait for three seconds to save the change.
Now the controller is in the standby mode.
6.
Press the key.
The screen returns to the SV/PV display.
To Next Page
Loading...
