Fuji Electric Micro-Controller X Socket type - Page 25

23
1st block parameter
[Setting example] Starting the ramp soak program ––––––––––––––––––––––––
Display Operating procedure
1.
Press and hold the key for about one second during the SV/PV display.

appears.
2.
Press the key to display .
3.
Press the key.

The setpoint starts blinking.
4.
Press the or keys to change “ oFF ” to “ RUN .”
5.
Press the key or wait for three seconds to save the change.

The ramp soak program starts.
6.
Press the key.

The screen returns to the SV/PV display.