Fuji Electric Micro-Controller X Socket type - Page 58

56
Parameter functions and setting procedure
[Setting example] Setting the ramp soak mode to 1 ––––––––––––––––––––––––
Display Operating procedure
1.
Press and hold the key for about three seconds during the SV/PV display.

appears.
2.
Press the key to display .
3.
Press the key.

The setpoint starts blinking.
4.
Press the key to change “ 0 ” to “ 1 .”
5.
Press the key or wait for three seconds to save the change.
6.
Press the key.

The screen returns to the SV/PV display.