Fuji Electric Micro-Controller X Socket type - Page 71

69
3rd block parameter
[Setting example] Hiding the integral time [i] and the derivative time [d] ––––––––
<Preparations>

Check the mask DSP of the parameter(s) you want to hide.
(the mask DSP of the integral time [i] is “dSP3-4,” the mask DSP of the derivative time [d] is “dSP3-4.”

If you want to hide multiple parameters of the same code, calculate the hexadecimal number of the
total integer.
Display Operating procedure
1.
Press and hold the key for about ve seconds during the SV/PV display.

appears.
2.
Press the key to display .
3.
Press the key.

The setpoint starts blinking.
4.
Press the , or keys to change “ 0000 ” to “ 000C .”
5.
Press the key or wait for three seconds to save the change.
6.
Press the key.

The screen returns to the SV/PV display.
The integral time [i] and the derivative time [d] are hidden.
If you want to reshow the derivative time [d], carry out the steps 1 to 3, and then change
the setpoint from “ 000C ” to “ 0004 .”