105
[System Settings]
[System Clock / Timers]
[Date]
Specify the date of the machine clock.
[Time]
Specify the time of the machine clock.
[NTP Time Synchronization]
Acquire the time from a time server (NTP), and then adjust the time of the machine to match it.
[Connection Interval]
Specify the interval for connecting to a time server.
[Time Server Address]
Specify the server name or IP address of the time server.
[Auto Clear]
Specify the time to reset when no operation is performed for certain time.
Note
Even when [Off] is configured, if no operation is performed for one minute when a document has been imported, and the
screen is in operation standby for the job, operation standby is exited, and processing of the imported document starts.
[Auto Job Release]
Specify the time until it is possible to clear the current job and run the next job when an error (paper loading, paper
jam, etc.) has occurred.
[Auto Print]
Configure the time until printing is possible after an operation of the control panel (excluding [Start]).
[Time Zone]
Configure in a range from -12 hours to +12 hours from Greenwich Mean Time (GMT).
[Daylight Savings]
Configure daylight savings time. During the interval set for daylight savings time, one hour is added to the current
time.
[Warmer Mode]
Configure whether to enter warm-up mode to prevent or reduce dew condensation.
If the [On] checkbox is selected, and [Start Time] and [Duration] are specified, the system runs in Warmer Mode
from [Start Time] until [Duration].
If the [Auto Start] is selected, a condensation state is predicted, and the condensation phase is entered, Warmer
Mode operation is activated automatically regardless of [Off]/[On]. If the specified [Start Time] results, the
system transitions to Warmer Mode.
When the [Auto Stop] box is checked, the warmup mode is automatically disabled if no dew condensation occurs
for a fixed period of time.
To Next Page
Loading...
Need help?
General
