5.6 Printing Report/List
157
Maintenance
5
016-711 (Out of PCL6
Memory)
Cause: PCL6 print data cannot be processed because of
the necessary memory is insufficient.
Action:
I
f the <Print Mode> is <Super Fine>, change the
setting to <High Quality> and retry. If the problem
is still not corrected, retry after changing the setting
to <Standard>.
4.10 Setting Print Mode (P. 79)
016-702 (Out of Page Buffer) Cause: PCL6 print data cannot be processed because of
insufficient memory.
Action: Take one of the following actions:
●
If the <Print Mode> is set to <Super Fine>,
change it to <High Quality>.
If the problem is still not corrected, change to
<Standard>
●
Use the page print mode.
●
Increase the print page buffer capacity.
●
Increase the memory.
For information about <Print Mode>, refer to “4.10
Setting Print Modes” (P.76). For information about the
page print mode, refer to the on-line help of the print
driver. For information about the print page buffer,
refer to “1.5 About Allocation of Memories“ (P.20).
016-721 Cause: An error occurred during print processing because
of the following reasons:
(1)
Although [Paper Type Priority] of <Print Set-
tings> in the Common Menu is set to <Off> for
all paper types, print is instructed with the Auto-
matic Tray Selection specified.
(2) Wrong ESC/P command
Action: For information about (1), set [Paper Type Prior-
ity] to other than <Off> for at least one paper type
when printing with the Automatic Tray Selection
specified.
For information about (2), check the print data
Paper Priority (P. 293)
Error message Cause and Action
To Next Page
Loading...
Need help?
General
