5.6 Printing Report/List
158
Maintenance
5
016-726
Cause:
When the print mode is specified to <Auto>, print
language cannot be selected automatically.
The possible causes are as follows:
PDF file is directly sent to the printer using LPR
without installation of built-in expansion hard
disc.
Action: Installation of built-in expansion hard disc is
required.
016-730 Cause: Unsupported command is detected.
Action: Check the print data. Delete the command that
causes the error and then retry.
016-748
016-793
Cause: Printing cannot be processed because of insuffi-
cient hard disc space.
Action: Decrease the number of print pages by dividing the
print data or, if multiple number of copies are
printed, change to 1 copy.
016-760 Cause: An error occurred during PostScript processing.
Action: Take one of the following actions:
●
Change the <Print Mode> to <High Quality>.
●
Increase the print page buffer.
●
Increase the memory using PostScript.
For information about <Print Mode>, refer to “4.10
Setting Print Modes” (P.76). For information about the
print page buffer and memory that uses PostScript, refer
to “1.5 About Allocation of Memories” (P.20).
016-761 Cause: An error occurred during image processing.
Action:
C
hange <Print Mode>
to <High Quality> and retry.
If the problem is still not corrected, use the page
print mode.
For information about <Print Mode>, refer to “4.10
Setting Print Modes” (P.76). For information about the
page print mode, refer to the on-line help of the print
driver.
016-762 Cause: Print language not installed is designated.
Cause below is possible:
(1) HP-GL/2 or PCL data is sent while emulation kit
is not installed.
Action: (1)Installation of emulation kit is required.
016-749 Cause: A text error occurred to PJL command.
Action: Check the print settings or correct the PJL com-
mand.
Error message Cause and Action
To Next Page
Loading...
Need help?
General
