6.5 List of Messages
228
Troubleshooting
6
RemovePaper fromTop Tray
of G
↓↑
Open G. Open 2a.Turn 2c to
clear
Cause: A paper jam has occurred inside the finisher.
*These messages are displayed alternately.
Action: Open the finisher front cover, open [2a], and turn [2c] to
remove the jammed paper.
“6.2.8 Paper Jams in the Finisher”(P.205)
RemovePaper fromTop Tray
of G
↓↑
Open G. Open 2a.Clear jam
Cause: A paper jam has occurred inside the finisher.
*These messages are displayed alternately.
Action: Open the finisher front cover, open [2a] and remove the
jammed paper.
“6.2.8 Paper Jams in the Finisher”(P.205)
Empty G top tray Cause: The output tray is filled up.
Action: Remove the paper on the output tray.°
“3.1 Main Components and Their Functions”(P.30)
Empty G bottom tray Cause: The booklet tray is filled up.
Action: Remove the paper on the booklet tray.°
“3.1 Main Components and Their Functions”(P.30)
RemovePaper fromCenter
Tray of
Cause: The finisher tray is filled up.
Cause: Remove the paper on the finisher tray.
“3.1 Main Components and Their Functions”(P.30)
Obstructed.CheckBelow Tray
G
Cause: An obstacle exists under the finisher tray.
Action: Remove the paper on the finisher tray first to remove the
obstacle for resetting from the error.
“3.1 Main Components and Their FunctionsÅv(P.30)”
Ém Close Front Cover at G Cause: The finisher front cover (G) is open.
Action: Close the finisher front cover (G).
“3.1 Main Components and Their Functions”(P.30)
Close Cover of 5on right of G Cause: The ejecting port cover (5) on the right side of the finisher is
open.
Action: Close the ejecting port cover (5) on the right side of the fin-
isher.
“3.1 Main Components and Their Functions”(P.30)
Message Cause/action
To Next Page
Loading...
Need help?
General
