6.5 List of Messages
248
Troubleshooting
6
016‑760
[Cause] An error occurred during PostScript processing.
[Action] Take one of the following actions:
●
Set [Print Mode] to [High Quality].
●
Increase the print page buffer capacity.
●
Increase the memory used by PS.
"4.10 Setting Print Modes" (P.76) for the print mode.
"1.5 About Allocation of Memories" (P.20) for the print page buffer
and the memory used by PS.
016‑761
[Cause] An error occurred during image processing.
[Action] Set [Print Mode] to [High Quality] and try to print again. If the
problem still persists, try to print again after setting [Print Page
Mode] to [On] and [Print Mode] to [High Quality].
"4.10 Setting Print Modes" (P.76) for the print mode.
For information about [Print Page Mode], refer to the Online Help for
the print driver.
016‑762
[Cause] A print language, which is not installed, is specified.
[Action] This printer can process PCL, ESC/P, HP-GL, HP-GL2, TIFF,
PDF, and PostScript data as standard. To send other print data,
install the option for processing the respective language.
016‑764
[Cause] Cannot connect to the SMTP server.
[Action] Consult with the administrator of the SMTP server.
016‑765
[Cause] Mail cannot be sent because the internal hard disk of the SMTP
server is full.
[Action] [Action] Consult with the administrator of the SMTP server.
016‑766
[Cause] An error occurred on the SMTP server.
[Action] Consult with the administrator of the SMTP server.
016‑767
[Cause] Mail cannot be sent with response code 550, 551 or 553 received
from the SMTP server because of incorrect destination mail
address specification.
[Action] Check the destination mail address and send the mail again.
"4.14.1 Setting up the Environment for E-mail Printing"(P.93)
016‑768
[Cause] Cannot connect to the SMTP server because the printer's e-mail
address is not correct.
[Action] Check the printer's e-mail address.
“4.14.1 Setting up the Environment for E-mail Printing”(P.93)
Error code Cause/action
To Next Page
Loading...
Need help?
General
