Fujitsu ETERNUS DX100 S3 - Page 398

Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
398
(4) Click the [OK] button
 Returns to the [Manual Input] screen.
(5) Repeat Step (2) through Step (4) to set more iSCSI hosts.
If an error screen appears under the following conditions, check the parameter settings.
• The "iSCSI Name" is not entered
• The "iSCSI Name" does not satisfy the input conditions
• The "IP Address" does not satisfy the input conditions
• The "Alias Name" does not satisfy the input conditions
• The "CHAP User ID" does not satisfy the input conditions
• The "CHAP Password" does not satisfy the input conditions
• The "Confirm CHAP Password" does not satisfy the input conditions
• The "CHAP Password" and the "Confirm CHAP Password" do not match
• Either of the "CHAP User ID" or the "CHAP Password" has been specified
If an error screen appears under the following conditions, check the parameter settings.
• The "Host Group Name" is not entered
• The "Host Group Name" does not satisfy the input conditions
• The "Host Group Name" overlaps with an existing host group name (Host group names cannot
overlap with any other host group names, irrespective of the interface types.)
• The same iSCSI name is specified for multiple iSCSI hosts
• When the "IP Address" is specified and an iSCSI host with the same "iSCSI Name" and "IP Address" is
already registered
• When the "IP Address" is not specified and an iSCSI host with the same "iSCSI Name" and "IP
Version" is already registered
• The "Alias Name" overlaps the existing Alias name
• A host cannot recognize some LUNs
• No hosts are registered in the host group, or more than eight hosts (or more than 64 for the
ETERNUS DX8700 S3/DX8900 S3) are registered
• The total number of hosts has exceeded the maximum number for the ETERNUS DX