Fujitsu FLASHWAVE 7500 - Installing the Circuit Breaker Panel or Fuse Panel

CHAPTER 3
Small Configuration
Installing the Circuit Breaker Panel or Fuse Panel
3-29
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
3.6 Installing the Circuit Breaker Panel or Fuse Panel
The circuit breaker panel (CBP) (see Figure 3-17 [p. 3-29]) or fuse panel (see the note that
follows) should be the first item installed in the rack. For procedures to install the CBP, refer
to Circuit Breaker Panel. After the CBP or fuse panel is installed at the top of the rack, the
other equipment can be installed.
Note: Fujitsu does not manufacture a 19-inch CBP. For 19-inch rack applications, Fujitsu
recommends using the N215116-N/L31 fuse panel manufactured by Noran Tel Ltd. Refer to
Noran Tel documentation for installation instructions for the N215116-N/L31 fuse panel. This
unit can be ordered through Fujitsu using part number 06-331-444.
Note: The CBP may not have circuit breakers CB1 through CB4 installed. Locate the
HA15B-0001-C365 circuit breaker kit, if required, for labels and circuit breaker units.
Figure 3-17: Circuit Breaker Panel, HA15B-001-B361
-48V
A1
GND
PW
R
-48V
A2
GND
PW
R
-48V
B1
GND
PW
R
-48V
B2
GND
PWR
FUSE MINOR MAJO
R CRITICAL
CB1 CB2 A POWER
CB3 CB4
CURRENT
RATING
CIRCUIT
A
PWR1
A
PWR2
A
PWR2
A
PWR1A1A2A2A
1
CB1CB2 B PO
WER
CB3 CB4
CU
RRENT RA
TING
C
IRCUIT
A
PWR1
A
PWR2
A
PWR2
A
PW
R1B1B2B2B1
FAN A
3A
FAN B
3A
d7206.fh8_2
Revision 1, June 2009