CHAPTER 3
Small Configuration
Overview
3-3
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
3.1 Overview
This chapter provides prerequisites and procedures for installing a rack and installing or
connecting the shelves, plug-in units, and cables that make up the FLASHWAVE® 7500 Small
Configuration system. This chapter also describes the basic rack configurations for the
FLASHWAVE 7500 Small Configuration system. Additionally, this chapter describes the
backplane of the FLASHWAVE 7500 Optical/Tributary shelf. Procedures for attaching cables
to the Optical/Tributary shelf backplane are provided in Section 3.19, Installing Cables
[p. 3-108].
Note: In a Small Configuration, the Optical/Tributary shelf is the 19-inch Universal shelf. The
name of a specific shelf depends on its function (determined by the connections to its backplane
and the plug-in units installed). An Optical shelf supports the main ring wavelength division
multiplexing (WDM) facilities; a Tributary shelf provides client services.
The information contained in the following sections applies to all Small Configuration
applications, including Universal ILA, Express, 40-Ch WSS, 40-Ch 2D-ROADM, 32-Ch
ROADM, and 32-Ch FOADM.
The 2D-ROADM system requires one optical shelf and several tributary shelves.
Before performing the installation procedures, review the following subsections describing
prerequisites, standard rack configurations, and flange kits.
3.2 Prerequisites
Insure that all FLASHWAVE 7500 Small Configuration equipment has been received, and all
data forms and job engineering drawings have been completed and are available.
The tools required for performing procedures listed in this chapter include the following:
■
Common hand tools
■
Digital multimeter (DMM)
To Next Page
Loading...