Fujitsu FLASHWAVE 7500 - Installing Fans and DCM Shelf; Installing Shelf Fans

CHAPTER 5
Extension Configuration
Installing Fans and DCM Shelf
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
5-20
Fujitsu and Fujitsu Customer Use Only
5.9 Installing Fans and DCM Shelf
This procedure provides instructions for installing the Extension shelf fans and the dispersion
compensation module (DCM) shelf (if required).
NO.SUBPROCEDURE PAGE
It includes the following subprocedures: Procedure
5.9.1 Installing Shelf Fans . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-20
5.9.2 Installing the 23-Inch DCM Shelf. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-21
5.9.1 Installing Shelf Fans
This procedure provides installation instructions for the four cooling fans used by the
Extension shelf (see Figure 5-7 [p. 5-20]).
Step Task
1 If not already done, unpack four fan plug-in units from the shipping container.
2 If not already done, install a fan filter in the fan tray located at the bottom of each fan unit.
3 Install the fan plug-in units into the bottom portion of each Extension shelf. (Refer to
Maintenance and Trouble Clearing, Section 8.8, Replacing FAN6 Plug-In Unit and Fan Filter
[p. 8-28] for a detailed information.)
Note: The connectors on the back of the fan engage the shelf backplane connectors and are secured
in place with an extractor lever (located on the left side of the fan assembly front panel).
This procedure is complete.
Figure 5-7: Fan Unit (Front View)
(Extension Configuration)
FAN6
FAIL/SVCE
FC9682FAN6
Iss. 01
m1656wy_1
Revision 1, June 2009