Fujitsu FLASHWAVE 7500 - Installing Cables; Overview; Prerequisites

CHAPTER 3
Small Configuration
Installing Cables
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
3-108
Fujitsu and Fujitsu Customer Use Only
3.19 Installing Cables
NO.SUBSECTION PAGE
This section includes the following subsections: Section
3.19.1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-108
3.19.2 Prerequisites. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-108
3.19.3 Optical/Tributary Shelf Backplane . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-109
3.19.4 Installing Modem Cable (Main Optical Shelf Backplane) . . . . . . . . . . . . . . . . . . . . . . . . . 3-110
3.19.5 Installing Housekeeping Cables (Main Optical Shelf) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-112
3.19.6 Installing Office Alarm Cable (Optical/Tributary Shelf ). . . . . . . . . . . . . . . . . . . . . . . . . . . 3-115
3.19.7 Installing OSS Cable (Optical Shelf ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-117
3.19.8 Installing LAN Cable (Optical/Tributary Shelf ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-118
3.19.9 Installing RICC Cable (Optical Shelf ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-121
3.19.1 Overview
The procedures provided in this section cover the connections made to the Optical/Tributary
shelf backplane of the FLASHWAVE 7500 Small Configuration system. A simplified
backplane illustration (see Figure 3-83 [p. 3-109]) shows the backplane connectors and
connector designations for the Optical/Tributary shelf.
All fiber cabling and connections to the shelf plug-in units are made during system turn-up.
Refer to System Turn-Up, for fiber cabling information. For a detailed description of
FLASHWAVE 7500 cables and shelf connectors, refer to Cable and Wiring Guide.
Note: Some of the connectors on the Optical/Tributary shelf backplane may be for future use.
However, this practice defines all connectors on the shelf backplane and applicable cables that
may be used in future releases.
Note: All cabling from the Optical/Tributary shelf backplane should be connected only to other
shelves and equipment within the same building.
3.19.2 Prerequisites
The tools required for performing the procedures listed in this section are as follows:
■
Cable termination tools
■
Common hand tools
Revision 1, June 2009