Fujitsu FLASHWAVE 7500 - Installing OSS Cable (Optical Shelf ); Installing OSS Cable (Optical Shelf)

CHAPTER 3
Small Configuration
Installing Cables
3-117
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
3.19.7 Installing OSS Cable (Optical Shelf)
This procedure provides instructions for assembling the OSS cable and installing it on the
Optical shelf backplane (CN12). Table 3-13 [p. 3-117] lists pertinent information for this
cable. Figure 3-88 [p. 3-117] shows the cable connector pinouts.
Step Task
1 Connect the cable to shelf backplane connector CN12 (Optical shelf). See Figure 3-83
[p. 3-109].
2 Connect the other end of the cable to the appropriate router or hub.
Note: The 21-094-xxx cable can also be used to connect a PC to the TERM2 Ethernet port on the
Optical shelf front panel.
Note: The OSS port has automatic cable-detect capability to properly function with both crossover
and straight cables.
This procedure is complete.
Table 3-13: OSS Cable Information
(Small Configuration)
Cable Part
Number
Backplane
Connector
Number
Cable Description
Connector
Type
Cable Wire
Size
21-332-xxx or
21-094-xxx
a
a
xxx = length in feet
CN12 Ethernet connection 8-pin RJ-45 24 AWG
Figure 3-88: Connector Pinouts, OSS Cable
1
2
3
4
5
6
7
8
TXP
TXN
RXP
RXN
m1714au_1
Revision 1, June 2009