CHAPTER 3
Small Configuration
Storing, Unpacking, and Inspecting Equipment
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
3-20
Fujitsu and Fujitsu Customer Use Only
3.4 Storing, Unpacking, and Inspecting Equipment
This section describes how to store, unpack, and inspect the FLASHWAVE 7500 equipment.
It includes the following subsections: Section
3.4.1 Storing Equipment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-20
3.4.2 Unpacking and Inspecting the Equipment Rack. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-20
3.4.3 Unpacking and Inspecting Equipment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-24
Note: Review Section 3.5 [p. 3-25] for rack installation criteria.
3.4.1 Storing Equipment
When equipment is to be kept in storage, the equipment should be left in the shipping
containers. The storage bags are coated with a conductive material to protect plug-in units
from damage by electrostatic discharge (ESD). Observe all warning labels used by Fujitsu to
indicate electrostatic-sensitive devices.
3.4.2 Unpacking and Inspecting the Equipment Rack
This procedure provides guidelines for unpacking and inspecting a standard rack. Fujitsu
recommends that the installation team familiarize themselves with the specific area where the
installation is to be performed, examine the racks, and ensure that sufficient workspace to
unpack the racks is available.
Improper handling of the equipment rack can result in serious injury or death. Always use a
forklift or lifting sling with block and tackle to lift or move the equipment rack. Keep all
personnel clear of the equipment rack while it is being lifted. Do not attempt to handle and
install the racks without sufficient assistance.
Follow this procedure to unpack and inspect the equipment rack:
1 Identify the equipment rack to be installed.
To Next Page
Loading...