Fujitsu FLASHWAVE 7500 - 2.10 Installing Power, Ground, and Alarm Cables; 4.11 Installing the ETSI LAM;DCM Shelf (SDL1)

CHAPTER 2
Core Configuration
Installing the Circuit Breaker Panel
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
2-20
Fujitsu and Fujitsu Customer Use Only
2.6 Installing the Circuit Breaker Panel
The circuit breaker panel (CBP) (see Figure 2-11 [p. 2-20]) should be the first item installed
in the rack. For procedures to install the CBP, refer to Circuit Breaker Panel. After the CBP is
installed at the top of the rack, the other equipment can be installed.
Note: The CBP may not have circuit breakers CB1 through CB4 installed. Locate the
HA15B-0001-C365 circuit breaker kit, if required, for labels and circuit breaker units.
Figure 2-11: Circuit Breaker Panel, HA15B-001-B361
-48V
A1
GND
PW
R
-48V
A2
GND
PW
R
-48V
B1
GND
PW
R
-48V
B2
GND
PWR
FUSE MINOR MAJO
R CRITICAL
CB1 CB2 A POWER
CB3 CB4
CURRENT
RATING
CIRCUIT
A
PWR1
A
PWR2
A
PWR2
A
PWR1A1A2A2A
1
CB1CB2 B PO
WER
CB3 CB4
CU
RRENT RA
TING
C
IRCUIT
A
PWR1
A
PWR2
A
PWR2
A
PW
R1B1B2B2B1
FAN A
3A
FAN B
3A
d7206.fh8_2
Revision 1, June 2009