Fujitsu FLASHWAVE 7500 - Installing Aisle End Panels

CHAPTER 4
ETSI Configuration
Installing Fans, Rack Covers, and End Panels
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
4-60
Fujitsu and Fujitsu Customer Use Only
4.12.3 Installing Aisle End Panels
This procedure provides instructions for installing the end panel on ETSI racks (see
Figure 4-43 [p. 4-61]).
Note: This panel is intended to prevent accidental removal of cards and fiber and is for an ETSI
only application.
Step Task
1 If not already done, remove the end panel and mounting hardware from the shipping
container.
2 Install the M5 screws and washers at the top of the rack, leaving approximately 1/8 inch to
allow the notch in the end panel to slip between the washer and the frame. See Figure 4-43
[p. 4-61].
3 Position the end panel over the M5 screws installed in Step 2 [p. 4-60], and lower the panel
until the screws are seated in the slots at the top of the frame.
4 Attach the bottom of the panel to the frame with M6 screws and washers.
5 Attach the cover panel with 8-32 screws.
This procedure is complete.
Revision 1, June 2009