CHAPTER 4
ETSI Configuration
Installing the Optical/Tributary Shelf
4-25
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
4.8 Installing the Optical/Tributary Shelf
The FLASHWAVE 7500 ETSI Configuration system is based upon the ETSI shelf
(FC9682SHU4), which can be configured as either an Optical or a Tributary shelf.
The ETSI rack must already be installed in accordance with local plans and procedures.
Figure 4-10 [p. 4-26] shows the Optical and Tributary shelf mounting in the ETSI rack.
Figures 4-11 [p. 4-27] and 4-12 [p. 4-28] show front views of the Optical shelf and the
Tributary shelf for reference.
Note: Figures 4-11 [p. 4-27] and 4-12 [p. 4-28] are shown fully populated for instructional
purposes. At installation, the shelves do not have plug-in units installed. The shelves are not
populated and provisioned until system turn-up.
Note: The FLASHWAVE 7500 shelves do not have front covers because of front-access fiber
cabling.
Do not attempt to handle and install the shelves without sufficient assistance. The
Optical/Tributary shelf weighs approximately 48.5 lb (22 kg) empty (without fans).
Equipped, the Optical/Tributary shelf weighs significantly more. Handling the equipment
without sufficient assistance may result in personal injury, damage to the equipment, or
both.
Do not use the internal walls of any shelf as a lifting point or lift support. Doing so may
damage the plug-in unit rail support.
Do not compromise the stability of the rack when installing this equipment. Unstable racks
can fall resulting in equipment damage.
To Next Page
Loading...