CHAPTER 4
ETSI Configuration
Rack Configurations and Shelf Flange Kits
4-3
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
4.3 Rack Configurations and Shelf Flange Kits
This section describes rack configurations and shelf flange kits for mounting shelves in the
racks.
It includes the following subsections: Section
4.3.1 Standard Rack Configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-3
4.3.2 Flange Kits for ETSI Racks. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9
4.3.1 Standard Rack Configurations
The FLASHWAVE 7500 ETSI Configuration system racks can be configured in several
variations. Fujitsu recommends ordering the top-level part number of a particular rack, which
would include the rack, the appropriate shelves and plug-in units, the rack wiring and cabling,
and other miscellaneous devices and equipment as required. The system racks are installed on
site in accordance with local plans and procedures.
Another consideration is to order racks populated with a minimum of shelves and then add to
the complement as required (the racks are wired for a full complement of shelves). In
addition, the FLASHWAVE 7500 ETSI Configuration system equipment, minus the rack,
can be ordered and installed in customer-supplied racks.
Figures 4-1 [p. 4-4] through 4-5 [p. 4-8] show the standard rack configurations for a
FLASHWAVE 7500 ETSI Configuration NE. For detailed procurement information, refer to
Ordering Information, or contact your Fujitsu sales representative.
To Next Page
Loading...