Fujitsu FLASHWAVE 7500 - Installing OSS Cable (Main Optical Shelf)

CHAPTER 2
Core Configuration
Installing Cables
2-69
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
2.13.7 Installing OSS Cable (Main Optical Shelf)
This procedure provides instructions for assembling the OSS cable and installing it on the
Main Optical shelf backplane (CN11). Table 2-6 [p. 2-69] lists pertinent information for this
cable. Figure 2-38 [p. 2-69] shows the cable connector pinouts.
Step Task
1 Connect the cable to shelf backplane connector CN11 (Main Optical shelf). See Figure 2-33
[p. 2-61].
2 Connect the other end of the cable to the appropriate router or hub.
Note: The 21-094-xxx cable can also be used to connect a PC to the TERM2 Ethernet port on the
Optical shelf front panel.
Note: The OSS port has automatic cable-detect capability to properly function with both crossover
and straight cables.
This procedure is complete.
Table 2-6: OSS Cable Information
(Core Configuration)
Cable Part
Number
Backplane
Connector
Number
Cable Description
Connector
Type
Cable Wire
Size
21-096-xxx or
21-094-xxx
a
a
xxx = length in feet
CN11 Ethernet connection 8-pin RJ-45 24 AWG
Figure 2-38: Connector Pinouts, OSS Cable
1
2
3
4
5
6
7
8
TXP
TXN
RXP
RXN
m1714au_1
Revision 1, June 2009