Fujitsu FLASHWAVE 7500 - Installing RICC Cable (Optical Shelf ); Installing RICC Cable (Optical Shelf)

CHAPTER 3
Small Configuration
Installing Cables
3-121
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
3.19.9 Installing RICC Cable (Optical Shelf)
This procedure provides instructions for connecting to the RICC ports on the Optical shelf
backplane. Table 3-16 [p. 3-121] lists pertinent information for these cables. Figure 3-91
[p. 3-121] shows the cable connector pinouts.
Note: The RICC cable is only required for HUB configurations.
Step Task
1 Connect the RJ-45 connector on one end of the RICC cable (21-332-xxx) to Main Optical
shelf backplane connector CN24, CN25, CN31, or CN32.
2 Connect the other end of the RICC cable to the appropriate Auxiliary Optical shelf backplane
connector indicated in Table 3-17 [p. 3-122].
Table 3-16: RICC Cable Information (Small Configuration)
Cable Part
Number
Backplane Connector
Number
Cable
Description
Connector
Type
Cable Wire
Size
21-332-xxx
a
a
xxx = length in feet
CN24, CN25, CN31, and
CN32 (Main and Auxiliary
Optical shelves)
RICC
connection
RJ-45 24 AWG
Figure 3-91: Connector Pinouts, RICC Cable
1
2
3
4
5
6
7
8
TXP
TXN
RXP
RXN
m1714au_1
Revision 1, June 2009