CHAPTER 3
Small Configuration
Installing the LAS2 Shelf
FNC-7500-0061-200
Issue 1, May 2009
FLASHWAVE 7500 Release 6.1
Equipment Installation
3-62
Fujitsu and Fujitsu Customer Use Only
3.13 Installing the LAS2 Shelf
This procedure includes the following subprocedures: Procedure
3.13.1 Install FC9503LAS2 Shelf . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-63
3.13.2 Install FC9682LAS2 Shelf . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-68
Two versions of the LAS2 shelf are available:
■
Shelf FC9503LAS2, shown in Figure 3-48 [p. 3-62], houses up to two lambda access
modules (LAMs) of type IPXP-LAM1.
■
Shelf FC9682LAS2, shown in Figure 3-49 [p. 3-63], houses up to sixteen LAMs of
type IPMA-LAM5.
Both versions of the LAS2 shelf contain only passive components and do not require any
power connections.
Note: Figures 3-48 [p. 3-62] and 3-49 [p. 3-63] are shown fully populated for instructional
purposes. At installation, the shelves do not have plug-in units installed. The shelves are not
populated until system turn-up.
Note: The LAS2 is a recommended fiber management option and may not be part of the
procured shelf complement. The FC9503LAS2 shelf houses the passive LAMs (LAM1) used to
terminate the MPO-to-MPO cable from the Optical shelf SWXP units (32-Ch ROADM application)
or MDXP units (32-Ch FOADM application) and output fiber pairs to the optical line cards
(OLCs). The FC9682LAS2 shelf houses the passive LAMs (LAM5) used to terminate the
MPO-to-MPO cable from the Tributary Shelf OLCs to FLASHWAVE LIGHTGUARD units.
Figure 3-48: FC9503LAS2—Populated with LAMs (Front View)
(Small Configuration)
To Next Page
Loading...