Fujitsu FLASHWAVE 7500 - Installing OSS Cable (Main Optical Shelf)

CHAPTER 4
ETSI Configuration
Installing Cables
4-81
FLASHWAVE 7500 Release 6.1
Equipment Installation
Fujitsu and Fujitsu Customer Use Only
FNC-7500-0061-200
Issue 1, May 2009
4.16.5 Installing OSS Cable (Main Optical Shelf)
This procedure provides instructions for installing the OSS cable on the Main Optical shelf
SIA (CN12). Table 4-4 [p. 4-81] lists pertinent information for this cable. Figure 4-53
[p. 4-81] shows the cable connector pinouts.
Step Task
1 Connect the cable to SIA connector CN12 (Main Optical shelf ). See Figure 4-51 [p. 4-78].
2 Connect the other end of the cable to the appropriate router or hub.
Note: The 21-094-xxx cable can also be used to connect a PC to the TERM2 Ethernet port on the
Optical shelf front panel.
Note: The OSS port has automatic cable-detect capability to properly function with both crossover
and straight cables.
This procedure is complete.
Table 4-4: OSS Cable Information
(Small Configuration)
Cable Part
Number
SIA Connector
Number
Cable Description
Connector
Type
Cable Wire
Size
21-332-xxx or
21-094-xxx
a
a
xxx = length in feet
CN12 Ethernet connection 8-pin RJ-45 24 AWG
Figure 4-53: Connector Pinouts, OSS Cable
1
2
3
4
5
6
7
8
TXP
TXN
RXP
RXN
m1714au_1
Revision 1, June 2009